brite-View Air SyncHD BV-2322 User Manual User Manual
Page 11
10
D.
On Screen Display (OSD) vs. RCU Instruction
POWER Button
(1)
Press the POWER button on the RCU pointed at the Transmitter or presses the POWER
button on top of the Transmitter to enter “Standby mode” from “Active mode”.
OSD Displayed:
▃▆█
▃▆█
▃▆█
▃▆█ HDMI1 CH10 WIDE Off 1280x1024
Standby Mode, Loop-thru Off
(2)
Press the POWER button on the RCU pointed at the Receiver or presses the POWER
button on top of the Receiver to enter “Standby mode” from “active mode”.
OSD Displayed:
▃▆█
▃▆█
▃▆█
▃▆█ HDMI1 CH10 WIDE Off 1280x1024
Standby Mode, Loop-thru On
Press the INFO button on the RCU, and Signal Quality, Source, Channel, WIDE mode status and
resolution will be displayed for user’s reference.
OSD Displayed :
▃▆█
▃▆█
▃▆█
▃▆█ HDMI1 CH10 WIDE Off 1280x1024
Press again to exit the OSD
Press the SOURCE button on the RCU or on the top of transmitter (or receiver) for IR blaster
frequency selection.
Press “SOURCE” button once for current IR blaster frequency displayed on the OSD:
▃▆█
▃▆█
▃▆█
▃▆█ [HDMI1] CH10 WIDE Off 1280x1024
IR Blaster Frequency [47KHz]
Press “SOURCE” button again within 5seconds to change IR blaster frequency.
▃▆█
▃▆█
▃▆█
▃▆█ [HDMI2] CH10 WIDE Off 1280x1024
IR Blaster Frequency [47KHz]