brite-View Air SyncHD BV-2322 User Manual User Manual
Page 21
20
Note:
A.
If there is no signal quality shown, and the Source & Status LED is blinking in blue, the
transmitter is most likely out of range. You may have to verify the range and adjust or shorten
the distance between the your HDTV set with the transmitter and the receiver. (The maximum
video transmission range for 1080p content is up to 66 feet in line of sight (LOS) scenarios.) <
The minimum range is 6.5 feet. > The transmission distance for 1080i content (WIDE mode on)
is up to 100 feet (Line of Sight).
B.
If the connection or link is lost, it may be caused by the following reasons:
a.
The range is over the maximum transmission distance.
b.
Either the transmitter or the receiver has been switched off.
C.
If the SOURCE LED continues to blink in blue (slower than “no signal mode”) and there is no
video displayed or the video quality suffers, this is an indication that the video frame rate from
the source device is not supported, or the transmission is out of range.