brite-View Air SyncHD BV-2322 User Manual - Manual (Page 15)

14
Step3: Setup the IR Blaster Extender Cable and IR Sensor Extender Cable
If necessary, connect the Infrared (IR) blaster (or sensor) Extender cable. Users can point
hand-held remote control of your high-definition AV equipment at the BV-2322R or the
HDTV set to operate the source devices, not exceeding the distance of 66 feet at
Line-of-sight.
(1) Plug the IR blaster cable into the IR
OUT jack of the BV-2322T.
Place the IR blaster head near the IR
sensor of your high-definition
audio/video devices nearby.
The infrared (IR) sensor should be close
to the front panel of your
high-definition device, usually behind a
dark and sometimes reddish plastic
window.
When the IR blaster cable is connected,
it relays infrared command from your
remote control at the device. Users can
control their AV devices by pointing
their remote control at the TV instead
of at their AV equipment.
(2)
If your connected device will be out of
the direct line of sight of your remote
controls, plug the IR Sensor Extender
cable into the IR IN jack at the rear
panel of the BV-2322R (receiver).
Note:
(1) The IR sensor supports 36 KHz ~ 56 KHz
(NEC, RC5, RC6) remote’s signal protocol.
Therefore, it is possible that some devices
may not be supported.
(2) The IR blaster supports 47KHz remote’
signal protocol.