ClearCube PCoIP System User's Guide - Manual (Page 54)

4.6 Viewing Pre-OS Video (BIOS Configuration) and USB Input
ClearCube Technology, Inc. 47
Setting up Devices
1. Be sure to have the following:

R-series blade in an R-series chassis. Note the MAC address shown on a label (VIDEO
V5xxx CONFIGURATION) on the side of the blade. This is the MAC address you will
select when connecting from the zero client.

Ethernet cables, zero client power supply, and a ClearCube zero client.

A switch connected to a DHCP network.

A USB keyboard and mouse.

Monitors and monitor power cables.
2. Insert the R-series blade into the chassis.
3. From the rear of the R-series chassis, connect an Ethernet cable to the secondary port that
corresponds with the slot that the blade is in (see the figure below). Connect the other end of
the cable to a network switch on the same subnet as the zero client.
Optionally, if you are imaging the blade, connect an Ethernet cable to the chassis slot’s
primary port and connect the other end of the cable to the imaging network switch.
Figure 21. Networking Module secondary ports for PCoIP connections (rear of chassis)
4. Power on the blade.
5. Connect monitors to the zero client.