ClearCube PCoIP System User's Guide - Manual (Page 56)

4.6 Viewing Pre-OS Video (BIOS Configuration) and USB Input
ClearCube Technology, Inc. 49
3. Press any key on the keyboard to restart the remote blade. The zero client should display the
message Waiting for host to wakeup, please wait… .
4. Press the F2 key several times to enter the BIOS setup utility.
5. Configure your BIOS as appropriate for your environment. After performing BIOS
configuration steps, press F10 to save and exit the BIOS. The blade now boots to the OS.
The zero client is now configured for direct connection to the host card you specified. If
necessary, you can return to the zero client configuration screen and change the session type back
to Direct to Host + SLP. See “
Configure the Zero Client
” on page
48 for instructions about
changing the connection type from the OSD’s Session tab.
4.6.2.2 Using a ClearCube C/Port (Analog)
The sections below show how to connected a ClearCube analog C/Port to single-slot blades (such
as an R3082D) and to dual-slot blades (such as an R3040S).
Single-slot blades:
When connecting a C/Port to an R-series blade, use the C/Port connector on the Connect
Bay Module that corresponds to the slot that the blade is in (as shown in the following figure, the
Connect Bay Module is located on the rear of the chassis on the far left side). For example, if a
blade is in chassis slot 3, connect your C/Port cable to C/Port connector 3.
You can connect the C/Port while the blade is off and then power it on to see pre-OS video, or
you can connect the C/Port while the blade is powered off and then power on the blade.
Dual-slot blades:
Dual-slot blades use two chassis slots. When connecting a C/Port to an R3040S blade in a chassis,
only use the C/Port connector corresponding to the even-number slot (slot 2, 4, 6, or 8) that the
blade is in. For example, if an R3040S blade is in chassis slots 3 and 4, connect the C/Port to
connector 4. If the blade is in chassis slots 7 and 8, connect the C/Port to connector 8.
You can connect the C/Port while the blade is off and then power it on to see pre-OS video, or
you can connect the C/Port while the blade is powered off and then power on the blade.