ClearCube PCoIP System User's Guide - Manual (Page 84)

6.6 Connecting to a Device
ClearCube Technology, Inc. 77
a. Briefly press and hold the power button on the front of the zero client to power it on. The
zero client displays a dialog box.
b. In the upper–left corner of the page, click Options > Configuration to open the
Configuration window. Click Unlock on the lower-left portion of the window to
display the Unlock dialog box. Click OK to unlock the window (you should not need to
type a password).
c. In the Network tab, ensure that the Enable DHCP option is cleared.
d. From the Connection Management tab, clear Enable Connection Management.
e. From the Discovery tab, select Enable Discovery and Enable Host Discovery.
f. Click Apply and then click Reset in the Attention dialog box to reset the zero client.
You can now continue to provision the host card on the blade.
4. Provision the host card on the blade.
a. Open a Web browser on a computer with a static IP address on the same subnet as the
host card you are provisioning.
b. In your browser, type the IP address of the host card to open the host’s Web interface.
c. From the Log In page, click Log In (you should not have to type a password).
d. From the Network page, ensure that the Enable DHCP option is cleared.
e. From the Connection Management page, clear Enable Connection Management.
f. From the Discovery page, select Enable SLP Discovery.
g. From the Session page, select Accept Any Peer.
h. Click Apply and then click Reset. The host card displays a power state message.
Click OK.
Briefly press and hold the reset button on your blade to reset it. You can now start your zero
client and click Connect to connect to your blade.