ClearCube PCoIP System User's Guide - Manual (Page 100)

93
Chapter 7.
Changing Device Peers
After deploying a zero client and allocating it to a host, you might need to change the host to
which the zero client connects. The steps below show how to change a device’s peer.
1. Ensure that you have:

Properly configured the zero client for the host to which you are connecting. For example,
if you are deploying a zero client that is using a fallback IP address or a static IP address,
make sure the host is on a compatible subnet and can connect to the zero client.

The IP address and MAC address of the new host peer.
2. Open the zero client’s Web interface by typing the zero client’s IP address in a Web browser
(see the OSD’s Options > Configuration menu for the zero client’s IP address).
3. From the Web interface, click Diagnostics > Session Control to display the Session Control
page. Click Disconnect to end the current session between the zero client and the host.
4. Click Configuration > Session to display the Session page. Select Direct to Host from the
Session Connection Type drop-down menu.
5. Specify values for the new host peer. Type the appropriate values for the new host in the
DNS Name or IP Address text box. Click Apply.
6. Click Configuration > Discovery to display the Discovery page. Ensure that the Enable
SLP Discovery option is cleared. Click Apply.