ClearCube PCoIP System User's Guide - Manual (Page 106)

8.3 Setting MSL on A-Series Blades
ClearCube Technology, Inc. 99
8.3.1 MSL on A6106D and Higher
Enable MSL on A-series blades A6106D and higher using PCoIP device firmware as described in
8.4 “ Setting MSL from a Zero Client or Host Card Web Interface ” on page 100 below.
8.3.2 MSL on A6105D and Lower
To enable MSL on A-series blades A6105D and lower with TERA1-based processors, move a
DIP switch on the blade’s host card (or the MSL jumper on V5120 host cards). Note the
following:

Always set MSL on the V5320 dual host card
A-series blades supporting PCoIP technology contain either a V5320 dual host card by itself
or a V5320 dual host card and a V5340 quad host card. V5340 quad host cards work in
tandem with V5320 host cards. When an A-series blade contains two host cards, set MSL on
the V5320 dual card only.

Setting MSL from the host card enables MSL on connected PCoIP devices.

When the host card’s MSL setting is enabled, software MSL (through a zero client or host
card Web interface) cannot override this hardware-based setting.
See A-Series Blade and Chassis User’s Guide for detailed instructions about working with
A-series blades.
1. Power down the blade and remove it from the chassis (if the blade is not in an enclosure—for
example, for maintenance—ensure that power is disconnected).
2. Place the blade on a flat surface and remove the three 6-32 screws on the top cover.
3. Slide the top cover back and remove it from the blade chassis.
4. Locate the A6105D blade’s host card. By default, all switches are set to off, as shown below.
To enable MSL, use a small device (such as the tip of a small screwdriver) to move the
switch in position 1. Move the switch to the on position, as shown in “MSL Enabled” in the
following figure.