ClearCube PCoIP System User's Guide - Manual (Page 72)

6.3 Using the Web Interface
ClearCube Technology, Inc. 65
To display the zero client and host Web-based interface, you must specify the device’s current IP
address in a Web browser. For information about how to find a device’s IP address, see
6.1
“ Finding a Device’s IP Address and MAC Address ” on page 56 .
To access a client or host Web interface, ensure that you have:
1. Open a Web browser on a computer on the same subnet as the zero client or host card you
want to access.
2. In your browser, type the IP address of the zero client or host card to display the Web
interface. Depending on your configuration you can use the default, fallback IP address of the
device; a static IP address; or a DHCP-assigned address that you have assigned. The
following list details the default, fallback IP address of each device.

Zero client—192.168.1.100

Host card—192.168.1.101
3. From the Log In page, click Log In and specify the password appropriate for your
environment. By default, you can click Log In without specifying a password.
6.3.1 Web Interface Details
See PCoIP Administrator’s Guide on the Teradici support site for detailed information about
PCoIP Web interfaces.
6.3.2 Using the On-Screen Display (OSD)
Zero clients display the OSD when powered on and a PCoIP session is not established. The
OSD’s Connect button enables zero client users to connect to a host device. Clients display the
Connect screen on startup. The following figure shows the OSD.