ClearCube PCoIP System User's Guide - Manual (Page 82)

6.6 Connecting to a Device
ClearCube Technology, Inc. 75
h. Click Configuration > Monitor Emulation. Select the monitor emulation option for
both monitors (DVI 1 and DVI 2).
i. Click Apply and then click Reset. The host card displays a power state message. Click OK.
Briefly press and hold the reset button on your blade to reset it. You can now start your zero
client and click Connect to connect to your blade.
6.6.2 Unmanaged Direct Connection with SLP Discovery
In the following table, the PCoIP configuration described in this section is circled in red.
Table 9. Unmanaged, SLP assignment with direct connection
Management
Managed
Environment
Unmanaged
Environment
Network
Topology
Peer Assignment
IP Assignment
CMS
Assignment
SLP
Discovery
Static
Assignment
Shared
DHCP
  ×
Reserved DHCP
  
Static IP
  
Direct
Connection
Static IP
×  
You can create a direct connection between a zero client and a host, where the zero client and
host are not connected to a network. Use this type of PCoIP deployment if, for example:

There is already a ClearCube deployment using direct connections (such as C/Ports) in
your enterprise.

If you do not want PCoIP traffic on your corporate network.
NOTE: ClearCube recommends using static IPs in this configuration. Using the zero client ’s or
host’s static, fallback IP addresses significantly increases the time for devices to become
available because fallback IP addresses are only available after a timeout period.