ClearCube PCoIP System User's Guide - Manual (Page 97)

Chapter 6. Configuring Devices, Setting Peers, and Connecting
90 PCoIP System User’s Guide

Disconnect
If the connection state is Connected or Connection Pending , click the Disconnect button
to end the PCoIP session. If the connection state is Disconnected , this button is disabled.
After you click the Disconnect button, it is disabled. You must refresh the page to use it again.

Peer IP Address
The Peer IP Address displays the IP address of the peer device. The field is blank when there
is no session.

Peer MAC Address
The Peer MAC Address displays the MAC address of the peer that is currently connected.
The field is blank where there is no session.
6.8.2 Setting Devices to Automatically Reconnect
You can configure zero clients to automatically reconnect to a host card when a PCoIP session is
lost. The setting, Enable Auto-Reconnect, is available in from the Session tab of the OSD’s
Configuration page. The auto-reconnect feature can produce different results depending on the
options set on the zero client. To enable a zero client to automatically connect to a peer when a
session is lost:
1. From the zero client’s OSD, click Options > Configuration.
2. Click Unlock and then click OK (or enter a password if one is set).
3. From the Session tab click Advanced, and then select Enable Auto-Reconnect.
4. Click OK.
5. From the Discovery tab, clear the Enable Discovery option.
Result: An Attention dialog is displayed.
6. Click Reset to reset the zero client.
Result: The OSD is displayed within several moments.