Lexicon MPX 1 - Manual (Page 57)

Lexicon MPX 1 User Guide
5-8
MIDI This menu contains all of the MPX 1 MIDI controls. The operation of each of
these controls is described here. More information on working with MIDI is
presented in Chapter 6.
The Pgm Change control allows you to enable or disable the Reception of MIDI
Program Change messages. The manner in which the MPX 1 interprets these
messages is determined by your selection here.
Off All Program Change and Bank Select messages are ignored. Pgm +
and Pgm - will load the next higher or lower program.
On Program Change messages 0-99 correspond to MPX 1 programs
1-100.
Options: Pgm# Offset, Pgm+ and Pgm-
Pressing Options from the Pgm Change display allows you to offset MPX 1
program numbers to match another MIDI device.
From Options you can also map Pgm+ and Pgm- controls to load the next
higher or lower program. The following sources can be selected to activate these
controls:
None
Tog 1-3
Sw 1-3
CC 1-119
Select 1-16, OMNI or Off for receipt of MIDI messages.
Select 1-16, or Off for transmission of MIDI messages.
If Transmit is active (set to any channel), you can select any of the controllers
shown to the side to transmit MIDI controller messages if they are used in a
patch.
The display presents two selection fields for mapping the controllers as shown
below.
Program Change
Press Options to access Pgm+
and Pgm- controls and to set a
program number offset. Press
Options again to return to the
MIDI menu.
Receive
Transmit
Ctl Send
None
On
Knob
Puls1
Tri1
Sine1
Cos1
Puls2
Tri2
Sine2
Cos2
Rand
Arp
ADR1-2
S/H
Env1-2
Mtr1-2
A/B
ATrg BTrg
ABTrg
Pedal
Tog 1-3
Sw 1-3
CC 1-31
CC33-119
Bend
Touch
Vel
Last Note
Low Note
High Note
Tempo
Cmnds
Gate
Trig
LGate
TSW
Ctl Send Selections
MIDI Ctl Send
< >
Knob= CC78
Two fields are available for mapping
MPX 1 controls to MIDI controllers.