Lexicon MPX 1 - Manual (Page 61)

Lexicon MPX 1 User Guide
5-12
Initialize Selecting any item in the Initialize menu will restore portions of the MPX 1 to their
factory default settings. These controls allow you to perform a complete reset of
the unit to its factory defaults, or to reset only selected functions.
For any displayed selection, the initialization procedure is the same. When a
selection is displayed, as in the Initialize All example shown below, the Store
button LED will flash, indicating that the MPX 1 is armed to perform the reset
procedure.
Press Store. The display query "Are you sure?" prompts you to select Yes or No
as a response. If you don't want to perform the initialization, press No to cancel
the operation. If you press the front panel Yes button in response to this
message, the procedure will be performed immediately. The message Init
Complete indicates that the procedure has been performed.
Note that the time for reinitialization will vary, with selections including DataBase
reset taking more time.
The selections in this menu are as follows:
All: Resets all MPX 1 parameters to their original factory settings.
This will erase all User programs and Setups.
User pgms only: Erases all User programs (program #s 201-250).
System only: Resets all MPX 1 parameters except User programs.
Controllers: Resets the MPX 1 internal controllers (Knob, LFOs, etc.) to their
default settings.
Bypass Patches: Removes any patches made between Bypass buttons and external
controllers.
Global Patches: Clears all global patches.
DataBase: Resets DataBase assignments for all programs.
This will remove DataBase assignments from programs 201-250.
Initialize
All
Are you sure?
Yes or No
Press Yes to initialize. Press
No to cancel the operation.
Select the initialization option you want.
The Store button will flash. Pressing it
will display the following message ...