Metrohm 850 Professional IC MSM-HC MCS Prep 3 - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
850 Professional IC Anion – MSM-HC – MCS – Prep 3
￭￭￭￭￭￭￭￭ 13
3 Installation
3.1 About this chapter
The Installation chapter contains
￭ this overview
￭ a brief set of instructions for the initial installation of the 850 Professio-
nal IC – Anion – MSM-HC – MCS – Prep 3 (see Chapter 3.2, page
13). At each step you will find cross-references to more detailed
installation instructions for individual components, should you require
such aids.
￭ an installation diagram (see Chapter 3.3, page 16), showing a com-
pletely installed 850 Professional IC – Anion – MSM-HC – MCS –
Prep 3.
￭ several chapters (see chapter 3.4, page 19 and following) with
detailed installation instructions for all components, including those
that are already installed at the time the instrument is delivered.
3.2 Initial installation
Note
A number of the capillaries is already connected at the time the instru-
ment is delivered.
The following work steps must still be carried out:
Installing 850 Professional IC – Anion – MSM-HC – MCS –
Prep 3
1 Setting up the instrument
(see Chapter 3.4, page 19).
2 Installations on the rear of the instrument
￭ Remove handle and rollers (see Chapter 3.6.1, page 21).
￭ Remove transport locking screws (see Chapter 3.6.3, page 26).
￭ Place the detector in the instrument and connect it (see Chapter
3.6.2, page 24).
￭ Connect the leak sensor (see Chapter 3.6.4, page 26).