2 deaerating the high pressure pump, Deaerating the high pressure pump – Metrohm 850 Professional IC MSM-HC MCS Prep 3 User Manual
Page 50
Advertising
3.10 High pressure pump
■■■■■■■■■■■■■■■■■■■■■■
40
■■■■■■■■
850 Professional IC Anion – MSM-HC – MCS – Prep 3
3.10.2
Deaerating the high pressure pump
The high pressure pump will only operate perfectly if the pump head con-
tains no more air bubbles. Therefore it must be deaerated during initial
start-up and after every change of eluent.
Caution
The high pressure pump must not be deaerated before the initial start-
up (see Chapter 4.1, page 76).
Deaerate the high pressure pump as follows (see Figure 20, page 41):
Advertising