Briggs & Stratton AA0101 - Manual (Page 8)

Document: - page 6 (Black)
Screen angle and frequency: 45.0000, 150.0000
GB
6
STORAGE
WARNING
• Stop the engine and let cool before removing the
outboard from the boat.
Avoid burns from HOT engine components. Use only
the tilt/carry handle at the rear of the outboard to tilt the
outboard.
REMOVING THE OUTBOARD
1. Stop the engine.
2. Close the air vent screw on the fuel tank cap. Disconnect
the fuel connector. Run the engine until it stops from lack
of fuel
3. Close the transport valve.
CAUTION: Failure to close the transport valve could
result in engine flooding and failure.
4. Loosen the mounting clamps. Carefully lift the outboard
from the transom.
STORING THE OUTBOARD
Fig. 13
Carry and store the outboard in a vertical position
Ê
.
If the outboard must be laid down for storage, it must rest on the
engine support
Ë
. Rotate the transom brackets to either side.
Move throttle arm up toward engine.
CAUTION: Storing or transporting the outboard
incorrectly WILL RESULT in oil spillage and engine
damage that is not covered by warranty.
SEASONAL STORAGE
1. While engine is still warm, change oil.
2. Remove spark plug and pour about 15 ml. or 0.50 oz. of
engine oil into cylinder. Replace spark plug and crank
engine slowly to distribute oil.
3. Change gear case oil.
4. Clean engine exterior. Wipe all components dry.
5. Apply grease to all sliding and moving components.
6. Store the outboard vertically in a dry area.
FUEL STORAGE
Engines stored over 30 days need to be protected with a fuel
stabilizer, or drained of fuel to prevent gum from forming in fuel
system or on essential carburetor parts.
PREĆSEASON CHECK
1. Fill the fuel tank with fresh fuel.
2. Allow engine to run for three minutes in NEUTRAL.
3. Run the engine for five minutes at the slowest speed.
TROUBLESHOOTING &
SERVICE
ENGINE WILL NOT START.
Gear selector not in the NEUTRAL position.
• Be certain the selector is in NEUTRAL.
Engine is not getting fuel (spark plug is dry).
• Verify fuel tank and engine connections are
correct.
• Fuel filter is plugged.
• Fuel hose plugged or kinked.
• Fuel transport valve closed.
• Fuel tank vent closed.
Check correct insertion of stop switch.
Check for damaged stop switch.
Fuel contaminated or old.
• Replace fuel, use fresh fuel only.
Carburetor float needle stuck or bent.
• Replace damaged parts.
No spark.
• Stop switch/ stop switch wire shorted.
• Ignition armature air gap incorrect.
• Ignition armature failure.
• Neutral switch operating incorrectly.
Engine is getting excessive fuel
(spark plug is wet.)
• Over choking.
• Water in fuel.
• Spark plug fouled - replace spark plug.
ENGINE QUITS WHEN SELECTING
GEARS.
Idle is set too low.
• Adjust idle speed.
Engine is not sufficiently warmed up.
• Allow engine to reach normal operating temperaĆ
ture before shifting.
Neutral switch not operating correctly.
• See an Authorized Briggs & Stratton Service
Dealer.
Plugged idle passage or carburetor jet.
• Clean or replace carburetor.
ENGINE RUNS ROUGH OR MISSES".
Engine speed limiter was activated.
• Check propeller for bent or broken blades,
incorrect mounting or slipping.
• Ventilation from high speed turns may activate
the speed limiter.
Ensure Ignition components are not wet.
Check for fouled spark plug.
Choke partially on.
• Move choke to the run position.
• Over choking.
SERVICE
We recommend that you see an authorized Briggs & Stratton
Service Dealer for all maintenance and service of the outboard
and outboard parts. Use only genuine Briggs & Stratton parts.
Each Authorized Briggs & Stratton Service Dealer carries a
stock of Genuine Briggs & Stratton Parts and is equipped with
special service tools. Trained mechanics assure expert repair
service on all Briggs & Stratton engines. Only dealers
recognized as Authorized Briggs & Stratton" meet the higher
Briggs & Stratton service standards.
You may locate your nearest Authorized Briggs & Stratton
Service Dealer in our dealer locator map on our web site
www.briggspowerproducts.com or in the

Yellow
Pages" directory under Engines, Gasoline" or Gasoline
Engines," or Lawn Mowers" or similar category.
Note: Walking fingers logo and Yellow Pages" are
registered trademarks in various jurisdictions.
REGISTRATION
MANUFACTURER'S STATEMENT OF ORIGIN
Some states require registration of outboard motors. A
Statement of Origin form has been included with your outboard
and contains the information necessary for registration.
In the U.S.A., to determine registration requirements, you
should contact the registering agency. This varies from state to
state, but is often the Secretary of State, Department of Natural
Resources, Department of Motor Vehicles, or local law
authorities may be able to provide registration information.
If outboard registration is required, fill out the front side of the
Manufacturer's Statement of Origin, retain the purchase
receipt, and follow the requirements of the registering agency.
Briggs & Stratton Corporation (B&S), the
California Air Resources Board (CARB)
and the United States Environmental
Protection Agency (U.S. EPA)
Emission Statement
THE STAR LABEL MEANS CLEANER MARINE
ENGINES.
The Symbol for Cleaner Marine Engines:
Cleaner Air and Water - for a healthier lifestyle and
environment.
Better Fuel Economy - burns up to 30Ć40% less gas and oil
than conventional carbureted two stroke engines, saving
money and resources.
Longer Emission Warranty - protects consumer for worry
free operation.
This engine has been certified as a:
ONE STAR - LOW EMISSION
The one star label identifies engines that meet the Air Resources
Board's 2001 exhaust emission standards. Engines meeting these
standards have 75% lower emissions than conventional carbuĆ
reted twoĆstroke engines. These engines are equivalent to the U.S.
EPA's 2006 standards for marine engines.
TWO STAR - VERY LOW EMISSION
The two star label identifies engines that meet the Air Resources
Board's 2004 exhaust emission standards. Engines meeting these
standards have 20% lower emissions than One Star - Low EmisĆ
sion Engines.
THREE STAR - ULTRA LOW EMISSION
The three star label identifies engines that meet the Air Resources
Board's 2008 exhaust emission standards. Engines meeting these
standards have 65% lower emissions than One Star - Low EmisĆ
sion Engines.