BridgeWave AR80 - Manual (Page 26)

AR/GE/FE/U 80/80X Installation Manual
21 580­00519 rev. D
3.8.3 Installation Instructions
1. Remove the protective liner from the plastic canopy
2. Use a screwdriver or 5/16” nut driver to set the hose clamp to the end of its range for
maximum opening
3. Slip the hose clamp over the radome so that it loosely sits in approximately the middle of the
radome.
4. Slide one end of the plastic canopy under the clamp and slowly bend it around the canopy
and work it under the rest of the clamp.
5. Align the canopy to the back edge of the radome and position the clamp 1 to 3” away from
the edge
6. Tighten the clamp until snug. (Do Not Overtighten)
Remove canopy when it’s not snowing to reduce antenna wind
loading