Krell Phantom Manual - Manual (Page 17)

17
Front Panel Description
See Figure 1 on the previous page
The Phantom Preamplifier is comprised of two chassis: the preamplifier chas-
sis and the power supply chassis. Front panel functions are described below:
Chassis
Preamplifier Chassis
The preamplifier front panel provides power on, input and zone selection, level
control, menu functions, and status display.
Power Supply Chassis
Powerful transformers, high quality regulators, and extensive electrical and
magnetic shielding are housed in a separate power supply.
Power
1 Power Button or Key
Use this button or key to switch the Phantom between the stand-by and oper-
ational modes.
7 Stand-by/Power LED
The preamplifier LED illuminates red and the power supply LED illuminates
green (stand-by) when the Phantom is plugged into a standard AC wall recep-
tacle. They illuminate blue (operational mode) when the power button (1) is
pressed while the Phantom is in stand-by mode.
Remote Functions on the Front Panel
2 Infrared Emitter
The stand-by/Power LED (7) flashes when the Phantom sends signals via this
infrared emitter to a programmable remote control. See IR Out Control, on
page 38.
4 Infrared Sensor
The infrared sensor receives commands from the Phantom remote control. For
proper remote control operation, make sure the infrared sensor is not covered
or obstructed.
(SECTION FOUR: Anatomy of an Phantom continued)