Krell Phantom Manual - Manual (Page 2)

Phantom Stereo Preamplifier
Owner’s Reference, v1.0
Krell Industries, LLC.
45 Connair Road
Orange, CT 06477-3650 USA
This product complies with the EMC directive (89/336/EEC) and the low-voltage directive
(73/23/EEC).
IMPORTANT SAFETY INSTRUCTIONS
1. Read Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all Instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not install near any heat sources such as radiators, heat registers, stoves, or other appa-
ratus (including amplifiers) that produce heat.
8. Unplug this apparatus during lightning storms or when unused for long periods of time.
9. Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as a power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
10. The Phantom preamplifier must be placed on a firm, level surface where it is not exposed to
dripping or splashing.
11. The ventilation grids on the top of the Phantom preamplifier and the space underneath the
Phantom preamplifier must be unobstructed at all times during operation. Do not place flam-
mable material above or beneath the preamplifier.
12. Before making connections to the Phantom preamplifier, ensure that the power is off and other
components are in mute or stand-by mode. Make sure all cable terminations are of the highest
quality, free from frayed ends, short circuits, or cold solder joints.
13. Do not connect an RS-232 cable to the phono power port. Output from the phono power port
can seriously damage your computer.
14. Do not connect the cable from a Krell KPE phono stage to the RS-232 port.
15. THERE ARE NO USER SERVICEABLE PARTS INSIDE AN PHANTOM PREAMPLIFIER.
Please contact Krell if you have questions not addressed in this guide.
This product is manufactured in the United States of America. Krell ® is a registered trademark of Krell Industries, LLC., and is restricted for use
by Krell Industries, LLC., its subsidiaries, and authorized agents. Evolution Bias ™ is a trademark of Krell Industries, LLC. and is a Krell technolo-
gy based on U.S. Patent No. 5,331,291. CAN Link ™, CAST ™, Evolution CAST ™, and Krell Current Mode ™ are trademarks of Krell Industries,
LLC. All other trademarks are registered to their respective companies.
© 2011 by Krell Industries, LLC. All rights reserved
TEL 203-298-4000
FAX 203-891-2028
E-MAIL [email protected]
WEBSITE http://www.krellonline.com