Revel Salon - Manual (Page 11)

Figure 7. Tilting a REVEL
ULTIMA STUDIO and
installing a pair of spikes.
INSTALLING SPIKES
After choosing a final placement, add the spikes (and covers, if
desired) by performing the following steps:
1. Remove spike feet and locking rings from the plastic bags.
2. Enlist the aid of friend to tilt a loudspeaker to one side and start
a pair of spikes, as shown in Figure 7. Use caution to avoid
touching the front tweeter and midrange. The tip of the spike
should extend about 1
1 ⁄
2
" from the bottom of the cabinet.
3. Assemble and tighten locking rings onto the front spikes.
4. Tilt the REVEL ULTIMA STUDIO in the other direction and
install the other pair of spikes in the same manner.
NOTE: If the loudspeaker is to be used on a hardwood or tile floor,
use supplied spike covers. Further adjustment of spike may be neces-
sary due to uneven floors.
5. Repeat steps 1 through 4 for the other loudspeaker.
REVEL ULTIMA STUDIO
Owner’s Manual
11
,,,
,,,,,,,,,
,,,,,,,,
,,,,,,,,
,,,,,,,,
,,,,,,,,,
,,,,,,,,,
,,,,,,,,,
,,,,,,,,
,,,,,,,,
,,,,,,,,
,,,,,,,,,
,,,,,,,,,
,,,,,,,,,
,,,,,,,,
,,,,,,
Locking
Ring
Spike
Cover
(for hardwood
or tile floor)
(Optional) Use Covers For
Hardwood Or Tile Floor
1 1 ⁄ 2 "