Revel Salon - Manual (Page 6)

WARNING
Figure 3. Unpacking a REVEL
ULTIMA STUDIO carton.
UNPACKING
IMPORTANT! Do not attempt to lift a REVEL ULTIMA
STUDIO from its packing carton alone – use at least two strong
people to unpack the product properly. To avoid injury, use
extreme care during unpacking. Always stand as straight as pos-
sible and use your leg muscles to lift the REVEL ULTIMA
STUDIO. Do not lift it while bending from the waist.
Each REVEL ULTIMA STUDIO is packed in its own carton with
a shipping weight of 164 pounds (74.5 kg). To avoid personal
injury and possible product damage, we strongly urge you to enlist
additional help before unpacking either carton.
To unpack a loudspeaker, perform the following steps:
1. Stand a REVEL ULTIMA STUDIO in an upright position.
2. Carefully remove all staples from rear flaps. Open the flaps and
tilt the unit forward so that the bottom flap can be positioned
under the carton, as shown in Figure 3.
3. Lay the unit on its back with all flaps open. Lift carton off the
unit and set it aside.
4. Place the REVEL ULTIMA STUDIO in an upright position
and then remove the four (4) foam packing strips from the
sides, as shown in Figure 4 (on the next page).
5. Tilt the cabinet forward and remove bottom rear end pad, using
caution to avoid touching the front tweeter or midrange.
6. Tilt the cabinet backward and remove bottom front end pad,
using caution to avoid touching the front tweeter or midrange.
REVEL ULTIMA STUDIO
Owner’s Manual
6
Tilt carton forward and
tuck bottom flap under
This end up Front
This end up Rear