Revel Salon - Manual (Page 16)

Figure 12. How to connect the
REVEL ULTIMA STUDIO in
a horizontal bi-amplified system.
CONNECTIONS (CONTINUED)
HORIZONTAL BI-AMPLIFIED SYSTEM
Using two amplifier channels, remove the shorting straps from the
rear panel; then connect each REVEL ULTIMA STUDIO, as
shown in Figure 12.
CAUTION: Failure to remove the shorting straps when bi-
amplifying may damage some amplifiers.
NOTE: If the “gain factor” of the two amplifier channels is not identi-
cal, a means of adjusting the input level of at least one of the channels
is required. Consult your Revel dealer for specific recommendations.
REVEL ULTIMA STUDIO
Owner’s Manual
16
Remove straps
for bi-wire
or bi-amp
Low Frequency Input High Frequency Input
+1 -1 0 +.5 -.5
Serial Number xxxx
Front Tweeter Level Rear Tweeter Level
Revel Corporation
Northridge, California
Made in U.S.A.
-3 0 Off
Remove straps
for bi-wire
or bi-amp
Low Frequency Input High Frequency Input
+1 -1
0 +.5 -.5
Serial Number
xxxx
Front Tweeter Level Rear Tweeter Level
Revel Corporation
Northridge, California
Made in U.S.A.
-3 0
Off
Install straps for
single-wired operation
Shorting Straps Removed
INPUT
(one channel shown –
use for low frequencies)
Amplifier
(rear)
INPUT
(one channel shown –
use for high frequencies)
Amplifier
(rear)
red wht
Connector
Panel
REVEL
ULTIMA
STUDIO
Rear
Pre-Amplifier
(rear) OUTPUT OUTPUT
(Optional “Y” Adaptor)
(one channel shown)