Revel Salon User Manual
Page 7
Figure 4. A REVEL ULTIMA
STUDIO with its inner
packing materials.
Figure 5. Installing the
optional top grille.
7. Remove top end pad, fabric sock, and plastic bag from the grille,
using caution to avoid touching the front tweeter or midrange.
8. Remove enclosed hardware and optional top grille (if present)
from recessed pockets in the top end pad. Install the top grille,
as shown in Figure 5.
9. Repeat steps 1 through 8 for the other loudspeaker.
NOTE: We recommend installing spikes after determining final
speaker placement (see discussion starting on next page).
After unpacking both units, carefully inspect each one for possible
damage due to shipping. If you discover any damage, immediately
contact your Revel dealer for further assistance. To move an
unpacked REVEL ULTIMA STUDIO (e.g., when experimenting
with placement), rock it side-to-side into place, using caution to
avoid touching the front tweeter and midrange.
Keep all packing materials for future shipping. In the unlikely
event a product will need repair, Revel will only accept a unit in its
original shipping carton. Using any other packing materials may
result in damage to the product and is not covered by the warranty.
See Service Information on page 23 for additional details.
REVEL ULTIMA STUDIO
Owner’s Manual
7
,
,,,,
,,,,,,
,,,,,,
,,,,,,,
,,,,,,,
,,,,,,
,,,,,,
,,,,,,,
,,,,,,,
,,,,,,
,,,,,,
,,,,,,,
,,,,,,
,,,,,,
,,,,,,,
,,,,,,,
,,,,,
,
,,,,
,,,,
,,,,,
,,,,,
,,,,
,,,,
,,,,
,,,
,,,,,,,
,,,,,,
,,,,,,
,,,,,,
,,,,,,,
,,
Top
Grille
Magnets
(in cabinet)
,
,,,,,
,,,,,,
,,,,,,
,,,,,,
,,,,,,,
,,,,,,,
,,,,,,
,,,,,,
,,,,,,,
,,,,,,
,,,,,,
,,,,,,,
,,,,,,,
,,,,,,
,,,,,,
,,,,,,,
,,,,,
,
Top End Pad
Hardware
Top Grille
(if present)
Foam Strip
(1of 4)
Bottom
Rear End Pad
Bottom
Front End Pad