Icnc xt – Tweco iCNC XT User Manual
Page 102
Advertising
iCNC XT
A-4
APPENDIX
Manual 0-5299
• Clicking on “SETUP” opens the Setup window.
• The iHC window can be minimized with the button on the far right that looks like a dash.
• There are two text fields at the top right corner of the iHC window. In a normal situation it should read “SYSTEM RUNNING” in the upper
field and “SYSTEM OK PARAMETERS READ” in the lower field. If the height control isn’t running or there is a connection problem it
reads “WAITING FOR REPLY...” on the lower text field. This message is also seen when parameters are read to the iHC Processor.
• You can monitor the status of the station by viewing colors changing on the screen. The number field after the cut height text shows
when the AVC is active.
Advertising