Icnc xt – Tweco iCNC XT User Manual
Page 45
Advertising
iCNC XT
Manual 0-5299
INSTALLATION
3-25
5. In SigmaWin software Navigate to Setup --> Adjust Offset --> Adjust the Speed and Torque Reference Offset.
6. Select Speed Reference tab.
7. Put your Drive Enable switch to ON. Adjust the Speed Reference value to zero by clicking either the +1 or -1. When you have reached
speed 0 (min-1) fine tune the drift by checking the drifting speed from iCNC setup 1.4. (first page of this section) Drift Adjustment. After
you are done put the Drive Enable switch to OFF, disconnect from the drive and repeat for all axes.
Advertising