Icnc xt – Tweco iCNC XT User Manual
Page 47
Advertising
iCNC XT
Manual 0-5299
INSTALLATION
3-27
4. Double click Speed reference input gain.
5. Increase the gain value so you get a wanted maximum speed and click OK. Please note a higher value will give a lower speed.
6. Click Write.
7. Check your new maximum speed from the iCNC setup Max speed adjustment page.
8. Repeat procedure to further fine tune your maximum speed. Repeat steps to all axes so each one has the same max speed.
9. When finished, put the Drive Enable Switch on the front of the controller to “OFF” and remove the USB cable from the drives.
Advertising