Icnc xt – Tweco iCNC XT User Manual
Page 96
Advertising
iCNC XT
5-38
OPERATION
Manual 0-5299
5.13.4. Point Marking
Tool location (X and Y)
This is the marker location measured from the torch or laser pointer.
SD1
This delay is typically not used but is fully available and programmable.
SD2
Typically used for a marker down delay. This is the time that it takes for the marker to descend to marking height.
SD3
This is the marking time, or the time the marking takes place.
SD4
This is a marker-up raise time, or the time it takes for the marker to climb up to travel height.
Move Delay
This delay is typically not used.
ED1
This delay is typically not used.
ED2
This delay is typically not used.
Move Delay
This delay is typically not used.
Advertising