Icnc xt – Tweco iCNC XT User Manual
Page 75
Advertising
iCNC
XT
Manual 0-5299
OPERATION
5-17
5.6.8 Ignition Switch
Pressing the ignition switch will activate the igniters (if installed).
5.6.9 Marker Down On/Auto Switch
• ON position will activate the marker down signal. This is only used for testing. Important note: This switch in the ON position will cause
the plasma start command to start the Marker instead of the plasma. If the Marker switch is in the OFF position even the marker will not
be activated.
• AUTO position is where you normally keep this switch.
Advertising