ClearOne DigiLinX User Manual
Page 100
TheaterLinX
13-5
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Figure 13-3
Connecting Analog In and Out
3.
Connect the appropriate control cable (IR or RS-232) from the TheaterLinX
Receiver IR or RS-232 port to the Receiver.
For RS-232 (used if a NetStreams A/V receiver driver is used), use the included
RS-232 cable. Go from the A/V Receiver RS-232 port on the TheaterLinX to
the DB9 RS-232 port on the Receiver.
For IR, use the included IR emitter cable and connect it from the A/V Receiver
IR port on the TheaterLinX and connect the emitter end so that it covers the
front of the IR reciever on the receiver on the AVR.
4.
To control the display through the TheaterLinX, connect the IR emitter like you did
for the Receiver, but use the Display IR port on the back of the TheaterLinX.
Your setup should now look like the following diagram assuming you are using analog
for the audio in and out.