Specifications, Connectors, Installation – ClearOne DigiLinX User Manual
Page 65: Specifications -2, Connectors -2, Installation -2
DigiLinX Installation and Design Guide
8-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
Specifications
Drivers included
Voltage sensor with pentiometer for adjustment
LEDs for IR and voltage sensing detection
Dimensions: 4 6/10” wide x 3 1/5” high x 1 6/10” deep (120mm x 89mm x 40mm)
(CL100); 9 1/2” wide x 1 3/4” high x 8 2/3” deep (244mm x 45mm x 220mm)
(CL9100-CS)
Weight: 1 lb. (0.6 kg) (CL100);3.25lbs (1.47kg) (CL9100-CS)
NetPower: 1.
Connectors
The following are connectors for the ControLinX:
Ethernet: one RJ45 connector
power input: two-pin Phoenix connector (included)
IR/RS-232: 3.5mm IR emitter (cable included) or 3.5mm to RS-232 (cable
included)
RCA input: for voltage trigger sensing (use an RCA to two-tinned lead cable - sold
separately).
Installation
Figure 8-1 shows how to install a ControLinX. To install a ControLinX, complete the
following steps:
1.
Configure the third-party system using the manufacturer’s instructions.
2.
Connect the IR emitter or RS-232 connector to the third party device.
3.
Connect a 16/2 cable from the power port of the ControLinX to a PowerLinX.
4.
The ControLinX CL-9100-CS can be rack mounted using the included rack mount
ears.