Emd drive, Caution – Wheatheart WHR 130 x 31-36ft Augers PTO-SD User Manual
Page 18
3. A
SSEMBLY
WHEATHEART - GHR130 & WHR130 GRAIN AUGERS
3.6. EMD D
RIVE
PTO-SD & EMD D
RIVE
M
ODELS
18
16652 R1
7. Slide non-spline end of PTO driveline onto input shaft on gearbox using a
1/4" x 1-1/2" square key. Tighten set screws securely.
Note:
The PTO driveline is non-separable. Do not extend beyond 80".
8. Install the PTO driveline transport saddle to auger tube about 3’ above
gearbox. Secure with two 7/16” x 1-1/4" bolts and locknuts.
9. Attach the drive shield to the shield mount with two 3/8" x 3/4" bolts and
washer locknuts, then slide this assembly over PTO driveline and attach to
gearbox with two 1/2” x 1" bolts and lockwashers (Figure 3.6).
Figure 3.6
3.6. EMD DRIVE
Upper sections of the driveshaft are factory installed. To install the lower section
follow the steps below.
CAUTION
Never use a PTO driveline without a shield in
good working order.
Do not exceed maximum recommended
operating length or 15
o
angularity of PTO
driveline u-joints.