ADS Environmental Services PrimeProbe2 QR 775016 A0 - Manual (Page 34)

PrimeProbe2 User Manual
30
message displays, press Enter again. The instrument will switch
over to standby mode. To re-activate the PrimeProbe2, hold down
any one of the three keys on the keyboard for more than 1 second.
In standby mode, the PrimeProbe2 consumes about 50 mA of
power.
Internal Data
 L2 keycode Allows the user to set a Level-2 access code. This
code may range from 00001 to 65535.
 Block Level Allows the user to set a level from 0 to 3. Each
level enables and disables certain functions.
 Load fact. Pres. Allows the user to reset the factory default
settings, eliminating previous settings entered by the user.
 Load user pres. Allows the user to save the current settings as
user pre-settings in the Save user pres. fields.
 Hours Represents the total amount of time the PrimeProbe2 has
been in operation. The user cannot edit this field.
 KS = Represents a sensor calibration factor and should not be
changed under any circumstances.