Bio-Rad Gel Doc™ XR+ System - Manual (Page 16)

Page 16 of 42
4.2.4 Installing the White Light Transilluminator (Optional)
To install the White Light Transilluminator, open the door to the enclosure and pull the
drawer completely toward you. Locate the power cable positioned on the left side (inside of
the enclosure) behind the slide of the drawer. Remove the black rubber that covers the
banana plug and insert it into the White Light Transilluminator outlet. Make sure that the
main power switch on the transilluminator is in the ON position. The transilluminator will
not illuminate. Power to the White Light Transilluminator is controlled from the membrane
touch pad. To use the White Light Transilluminator, place it horizontally on the UV
Transilluminator and press the TransWhite button on the membrane touch pad. When the
White Light Transilluminator is not in use, store it in the two plastic holders located at the
rear of the enclosure.
Storage of the White Light Transilluminator
4.2.5 Installing the Optional 17 mm or 25 mm Wide-Angle Lenses (ChemiDoc 
XRS only):
This installation guide covers installation of the optional lenses for the ChemiDoc  XRS
system. The following catalog numbers are covered under this category:
i. Lens f 0.95, 25 mm, Wide Angle
ii. Lens f 0.95, 17 mm, Wide Angle
The lens kit includes a lens and the Light Seal adapter ring. See pictures below:
25 mm Wide Angle Lens with
Light Seal Adapter ring
17 mm Wide Angle Lens with
Light Seal Adapter ring