Bio-Rad Gel Doc™ XR+ System - Manual (Page 35)

Page 35 of 42
Appendix A: Gel Doc XR System Cable Configuration
Connecting the cabling harnesses
a) Locate the Fire Wire cable. Connect one end of the Fire Wire cable connector to the Fire Wire
connector on the Camera and connect the other end to the Fire Wire connector on the PC/Mac
b) The Camera power supply cable should be plugged into the CCD Camera PWR connector.
c) Connect the serial cable to the connector labeled “SERIAL” on the hood and the other end of
this cable to the appropriate port on the PC or Mac USB to Serial Adapter.
d) Connect the MZL cable connector to the connector labeled “LENS” on the rear panel of the
universal hood.
The following table describes the connectors and their designations.
Label / Color Instrument / Connection
6-pin Fire Wire connector Fire Wire Connector of the PC or PCI Card
6-pin Fire Wire connector CCD Camera Fire Wire Connector
Camera Power Supply Cord/Power Supply Camera / PWR Connector
25 Pin D-SUB Serial Cable connector COM1 PORT/Back of Computer
5 pin DIN Cable from Motorized Zoom Lens Hood / LENS connector
Power Cable
from Power
Supply
MZL
CABLE
SERIAL CABLE
Fire Wire Cable
To Mains
110-240 VAC