Iris Sample Processing StatSpin® ThermoBrite Denaturation and Hybridization - Manual (Page 5)

1
Section
1
Unpacking and Installation
Inspect Packaging
The ThermoBrite and its accessories are delivered in one carton. If the instrument or
accessories have suffered any damage in transport, please inform your carrier immediately.
NOTE: Save shipping carton and components to simplify return should service be required.
Verify Contents
The package contains:
One StatSpin ThermoBrite (Model No. S500)
One Line Cord
One Operator’s Manual
Two Humidity Control Cards (Reorder # HC10- QTY 10)
Install System
1. Place the StatSpin ThermoBrite on a level surface suitable for laboratory instrumentation.
2. ThermoBrite has an intake fan located on bottom, assure no obstruction exist on intake.
3.
Ensure the ThermoBrite is placed at least 12” (30 cm) from the wall to allow for proper
cooling.
4. Position the StatSpin ThermoBrite away from direct sunlight and sources of heat or cold.
5. Verify voltage requirements located on serial number label on the rear of instrument .
Connect Power
Plug the instrument into a grounded outlet supplying the voltage and frequency indicated on
the serial number label.
Main power switch is located on the rear of the instrument, next to the line cord power entry
module.