FRIGIDAIRE FGUB2642LF - Manual (Page 10)

10

NOTE
DO NOT remove the ground screw from hinge.

NOTE
Use care while pulling the water tube from the
unit to be sure you do not kink the tube.
Press
Press
Water
Line
Approximately
5 Feet
DOOR REMOVAL INSTRUCTIONS
To remove the refrigerator doors:
1. Trace lightly around the door’s top
hinges with a pencil. This makes
reinstallation easier.
2. Disconnect the harness by grasping both
sides of the connector firmly, depress the
latch, and pull apart. Remove the two (2)
screws from the top hinge. Lift the door
off of the bottom hinge and set it aside.
3. Detach the water tube from the
connector located behind the
refrigerator and pull the tube back out
to the front of the unit. The connector
releases when you press inward on
the outer sleeve while pushing the
tube toward the connector then while
continuing to hold in the sleeve, pull
the tube away.
Getting through narrow spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1. Make sure the electrical power cord is
unplugged from the wall outlet.
2. Open the freezer drawer and remove
the toe grille (see “Installation” section).
3. Remove any food from the door
shelves and close the doors.
To remove the top hinge covers:
1. Remove the two (2) screws from each
cover over the top door hinges.
2. Lift inside edge of hinge cover and
tilt back.