FRIGIDAIRE FGUB2642LF - Manual (Page 13)

13

NOTE
All set screws should be tightened so the screw is below the surface of the handle. The
handles should be drawn tight to freezer and refrigerator doors with no gaps. Opening the
opposite door while tightening the Allen screw makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this happens,
tighten the set screws on the handles.
INSTALLING DOOR HANDLES
Door Handle Mounting Instructions for Frigidaire Gallery ®
1. Remove handles from carton and any other protective packaging.
2. Position fresh food handle end over upper and lower pre-installed shoulder bolts (A)
that are fastened into door, ensuring the holes for the set screws are facing towards the
opposite door.
3. While holding handle firmly against door, fasten upper and lower Allen set screws (B)
with supplied Allen wrench.
4. Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are
facing towards the first door.
5. Position freezer handle end over left and right pre-installed handle mounts that are
fastened to the door, ensuring the holes for the set screws are facing down.
6. While holding handle firmly against door, loosely tighten far right Allen set screw (B) with supplied
Allen wrench until there is no gap between handle and door.
7. Still holding the handle firmly to the door, firmly tighten far left Allen set screw (B) with supplied
Allen wrench.
8. Return to the far right Allen set screw (B) and firmly tighten with supplied Allen wrench.
Mounting Refrigerator Handles