FRIGIDAIRE FGUB2642LF - Manual (Page 32)

32
To replace your water filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the
filter replacement.
1. Turn Off the ice maker power switch.
2. Remove the filter by pushing on the
end/face of the filter.
3. Slide the old water filter cartridge straight
out of the housing and discard it.
4. Unpackage the new filter cartridge.
Using the alignment guide, slide it
gently into the filter housing until it
stops against the snap-in connector at
the back of the housing.
5. Push firmly until the cartridge
snaps into place (you should hear a
click as the cartridge engages the
snap-in connector).
6. Press a drinking glass against the
water dispenser while checking for any
leaks at the filter housing. Any spurts
and sputters that occur as the system
purges air out of the dispenser system
are normal.
7. After filling one glass of water, continue
flushing the system for about four
minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter
button
on the Ice & Water Dispenser control
panel for three seconds. When the
display changes from Red to Green,
the status has been reset.
CHANGING THE FILTER
Ordering replacement filters
Order new filters by calling 877-808-4195,
online at www.frigidaire.com/store, or through
the dealer where you bought your refrigerator.
You may want to consider ordering extra filters
when you first install your refrigerator.
Air Filter Replacement cartridge, part
#PAULTRA
Air filter (select models)
The air filter is located under the utility bin.
Replacing your PureAdvantage TM
air filter
To ensure optimal filtering of refrigerator
odors, you should change the air filter every
six (6) months (the filter status light on the
Touch Panel prompts you to replace the filter
after six (6) months).
1. Open the air filter door.
2. Remove the old filter and discard it.
3. Unpack the new filter and slide it into
the housing. The open face of the filter
should be installed facing downward.
4. To close the air filter door, push the top
and bottom to lock the door closed.
5. Press and hold the Air Filter Reset
button on the control panel for three
(3)seconds. When the display changes
from “Replace” to “Good,” the status
has been reset.
6. The Air Filter Reset will turn itself off
after a few seconds.