FRIGIDAIRE FGUB2642LF - Manual (Page 12)

12
DOOR REMOVAL INSTRUCTIONS

NOTE
Do not remove center screw from freezer
drawer. This is a factory adjustment.
CAUTION
Drawer is heavy. Use caution when lifting.
1. Lift drawer up and out to remove.
Installing Freezer Drawer
1. With lower slides pulled out, hang
drawer onto slide brackets ensuring
pins on each side are fully inserted into
slots on each side.
2. Reinstall four (4) drawer screws (two
(2) per side), tighten down, and close
drawer (C).
3. Check gasket seal around top, bottom,
and sides of freezer drawer.
4. If gasket is not sealed, open drawer
and slightly loosen four (4) drawer
screws (two (2) on each side) to allow
drawer to rotate.
5. Close drawer and recheck the seal
on the gasket (A). Open the drawer
grabbing by the sides in the center (B).
Be careful not to rotate the drawer.
Assembly
Pin
Slot
Cabinet
Drawer
Fully Extend
Drawer Slides
Install
Screws
(2) Each
Side
Grab
Drawer
at
Center
from
Both
Sides
then
Pull
Drawer
Out
Push
Against
Freezer
Drawer
6. Tighten four (4) drawer screws.
7. Recheck gasket seal.
8. Install the toe grille by fitting into
place.