Dell POWEREDGE R610 - Manual (Page 23)

About Your System 23
LCD Status Messages
The following LCD messages refer to events recorded in the System Event
Log (SEL). (The messages are shown here in "simple" text format.) For
information on the SEL and configuring system management settings, see
the systems management software documentation.
NOTE: If your system fails to boot, press the System ID button for at least five
seconds until an error code appears on the LCD. Record the code, then see "Getting
Help."
Viewing Status Messages
If a system error code occurs, the LCD screen will turn amber. Press the Select
button to view the list of errors or status messages. Use the Left and Right
buttons highlight an error number, and press Select to view the error.
Removing LCD Status Messages
For faults associated with sensors, such as temperature, voltage, fans, and so
on, the LCD message is automatically removed when that sensor returns to a
normal state. For other faults, you must take action to remove the message
from the LCD display:
• Clear the SEL — You can perform this task remotely, but you will lose the
event history for the system.
• Power cycle — Turn off the system and disconnect it from the electrical
outlet; wait approximately ten seconds, reconnect the power cable, and
restart the system.
Indicator Description
Link and activity indicators are off The NIC is not connected to the network.
Link indicator is green
The NIC is connected to a valid network link at
1000 Mbps.
Link indicator is amber The NIC is connected to a valid network link at
10/100 Mbps.
Activity indicator is green blinking Network data is being sent or received.