Cisco XR 12410 - Manual (Page 110)

Chapter 3 Installing the Cisco XR 12410 Router
Reinstalling Components After Installing the Chassis
3-28
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Reinstalling AC PEMs
Use the following procedure to reinstall the AC PEMs back into the chassis.
Step 1 Install the AC PEMs ( Figure 3-20 ):
a. Slide the power supply into the bay until it mates with its backplane
connector.
b. Lift the ejector lever into place and tighten the captive screw to securely seat
the power supply to the backplane connector.
Caution To prevent damage to the power shelf backplane connector, do not use excessive
force when inserting the power supply into the chassis.
Figure 3-20 Installing an AC PEM
Step 2 Repeat Step 1 for the other power supply.
Step 3 Go to the “Reinstalling the Blower Module” section on page 3-30 to install the
blower module.
93228
0
PWR OK
FAULT
TEMP
ILIM
0
PWR OK
FAULT
TEMP
ILIM