Cisco XR 12410 User Manual
Page 201
Advertising
5-29
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Chapter 5 Maintaining the Router
Removing and Replacing AC and DC Power Subsystem Components
Step 3
Eject the PEM from the chassis (
a.
Loosen the captive screw on the ejector lever and pivot the lever down to eject
the PEM from its bay.
b.
Pull out the PEM halfway from its bay.
Note
It is not necessary to completely remove the power supply. You can leave
the power supply in its bay while you replace the DC PDU.
Figure 5-17
Ejecting a DC PEM
Step 4
Remove the clear plastic safety covers over the PDUs (see
53388
Advertising