Cisco XR 12410 User Manual
Page 188
Chapter 5 Maintaining the Router
Removing and Replacing AC and DC Power Subsystem Components
5-16
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Step 5
Install the new power supply (
a.
Slide the power supply into the bay until it mates with its backplane
connector.
b.
Lift the ejector lever into place and tighten the captive screw to securely seat
the power supply to the backplane connector.
Caution
To prevent damage to the power shelf backplane connector, do not use excessive
force when inserting the power supply into the chassis.
Figure 5-9
Installing an AC Power Supply
Step 6
Power on the circuit breaker to that AC outlet.
Step 7
Plug the power supply cable into its AC outlet.
Step 8
Set the power switch to the on (1) position.
The (green) Pwr OK indicator on the front of the power supply should light. If the
indicator does not light, see the
“Troubleshooting the AC Power Supply
Installation” section on page 5-17
93228
0
PWR OK
FAULT
TEMP
ILIM
0
PWR OK
FAULT
TEMP
ILIM