Scilogex D2012 Micro-Centrifuge - Manual (Page 11)

D2012 High Speed Mini Micro-Centrifuge
www.scilogex.com Page 11
● Do not push or lean against the centrifuge while it is running.
● Do not run the centrifuge when fragments or sample solutions are left in the centrifuge chamber. Always keep the
centrifugal chamber clean.
● If the centrifuge makes strange noise during operation, stop it immediately and contact our service center. Notify
them of the warning code if displayed.
8. Operation
8.1 Normal operation
Turn on the power switch, centrifuge will display the running interface last time after passing the self-diagnostic
checks, see figure 8-1 below:
● Speed: 15000rpm. Running time: 12 minutes.
● The door lock is released.
Figure 8-1 The last running interface
Speed area Door status Time area
min ×100rpm
CAUTION ʽ
●Attach the rotor to the rotor shaft. Ensure the rotor is in position and connected with the shaft, tightening the
locking nut to secure the rotor with shaft, to prevent the rotor damaging the centrifuge.
●Ensure the rotor lid is firmly tightened to the rotor.
8.1.1 Rotor loading and removal
CAUTION ʽ