Scilogex D2012 Micro-Centrifuge - Manual (Page 5)

D2012 High Speed Mini Micro-Centrifuge
www.scilogex.com Page 5
CAUTION
● This centrifuge must be located on a firm and level table.
● Make sure the centrifuge is horizontal before running.
● Make sure the angle between the door and cover is greater than 70 degrees when opening the door.
● Be careful not put your fingers or hands between the door and cover while the door is open.
● Do not move or relocate the centrifuge when it is running.
● If fluid spills in the rotor chamber, please promptly clean and dry with a dry cloth to avoid sample
contamination.
● Ensure to remove any objects and fragments of the tubes dropped inside the rotor chamber before running the
centrifuge.
● Cautions with rotor
(1) Always check for corrosion and damages on the rotor surface before using it. Do not use the rotor if an
abnormality is found.
(2) Do not set the speed beyond the allowable minimum speed of the rotor kits (rotor or adapters). Make sure to
run it below the allowable minimum speed.
(3) Do not exceed the allowable imbalance.
(4) Use the rotor and tubes within their actual capacities.
(5) If the rotor is attached with a lid, ensure it is tightened before operation.
● If any abnormal condition occurs during operation, please stop it immediately and contact our service center.
Notify the service center is a warning code if displayed.
● Vibrations are likely to damage the centrifuge, contact our service center if abnormality observed.
ʽ