Sony DCR-TRV510 - Manual (Page 61)

■y»~-
Recording an image from a recorded
tape as a still image
Your camcorder can read moving picture data recorded on a tape and record it as a still
image in the built-in flash memory. The unit can also take in moving picture data
through the input connector and record it as a still image in the built-in flash memory.
Before operation
Insert a recorded tape.
(1) Set the POWER switch to VTR.
( 2 ) Press ► . The picture recorded on the tape is played back.
(3) Keep pressing PHOTO lightly until the picture from the tape freezes. The
CAPTURE indicator appears in the viewfinder or on the LCD screen.
Recording does not start yet.
(4) Press PHOTO deeper. The image displayed on the screen will be recorded in
the built-in flash memory. Recording is complete when the bar scroll indicator
disappears.
'
3
41^
STO 1/33 -0
CAPTUftE
4
STD
PHO TO PHO TO
3
IV
3
o
O
If you press PHOTO while playing back tapes recorded in the HiB/standard 8
system
"nre CAPTURE indicator appears without freezing the image.
Recording a still image from a tape immediately after turning on the power
Saving the data may take a little more time than usual. This is not a malfunction.
61