Timer activated operation, 3 set the timer to the desired time, 4 sethmertorec – Sony DTC-57ES User Manual
Page 39: When timer activated recording is finished, 2 turn on the dat deck, and insert the cassette, 4 set the timer switch to the play position, When timer activated piayback is finished, Note
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Timer Activated Operation
2 4
Use a commercially available audio timer to activate
recording or playback at a desired time.
Read the operating instructions for the timer and the
amplifier.
Timer Activated Recording
Timer Activated Playback
*1 Turn on the timer.
1 Turn on the timer.
2
Turn on the DAT deck, and prepare for recording.
(Foilow steps 2,3 and 5 on page 20.)
3
Set the timer to the desired time.
Power to the amplifier and to the OAT deck is turned off.
Leave the power switches of the equipment turned on.
4
SetHMERtoREC.
At the preset time, the power is supplied and recording
starts after about 4 seconds.
The AUTO indicator will be the same as the one before the
power of the DAT deck is turned off.
When the AUTO indicator lights, start IDs will be written
during recording.
When timer activated recording is finished
Be sure to set the TIMER switch to the OFF position.
Precautions
If the TIMER switch is left at the REC position, recording will
start when the power is turned on the next time, and the
tape contents will be erased.
In timer recording (the TIMER switch is set to the REC
position), the auto rewind function will not be activated
even if the tape is fully taken up. The tape stops without
being rewound so that recording will not be performed
over the previously recorded material.
Be sure to activate timer recording with the cassette
inserted properly in the cassette compartment. With the
cassette compartment lid opened, timer recording will not
function.
2
Turn on the DAT deck, and insert the cassette.
3
Set the timer to the desired time.
Power to the amplifier and to the DAT deck is turned off.
Leave the power switches of the equipment turned on.
4 Set the TiMER switch to the PLAY position.
At the preset time, the power is supplied and playback
starts after about 4 seconds.
When timer activated piayback is finished
Normally set the TIMER switch to the OFF position.
If you want to start playback at the preset time every day
automatically, leave the TIMER switch to the PLAY position.
Note
The built-in clock can be used only for the date function.
To record and playback at a desired time, use a
commercially available timer.
39