Sony SLV-789HF - Manual (Page 13)

t'
Selecting a
language
You can change tlie on-screen display
lanrpaagc.
t4
Press MENU, then press ♦/♦to highlight
SETTINGS and press OK.
When using the EASY SET UP procedure,
skip steps 1 and 2.
Press ♦/♦ to highlight LANGUAGE, then
press OK.
3
Presst/rtoHghlightENGUSH, ESPANOL, orFKANCAB, Ihen
press OK.
4 MCNU Press MENU to exit the men
• If you want to return to the previous menu, highlight RETURN and press OK
36 I Getting Started
Setting the clock
Using the Auto Clock Set
feature
Some TV and cable channels transnrit
time signals with their broadcasts. Your
VCK can pick up tlris tinre signal to
automatically set the clock.
The Auto Clock Set feature works only if
a channel in your area is broadcasting a
time signal. If broadcasters in your area
are not yet sending time signals, set the
time manually (page 43).
Before you start...
• Turn on the VCR and the TV.
• Set the TV to the VCR channel
(channel 3 or 4). If your TV is
connected to the VCR using A/V
connections, set the TV to video input.
• Pr£?ss TV/VTDEO to display the
VIDEO indicator in the VCR's display
window.
• Press INPUT SELECT so that a
channel number appears in the VCR's
display window.
t/4
Press MENU, then press ♦ /♦ to highlight
SETTINGS and press OK.
When using the EASY SET UP procedure,
skip steps 1 and 2.
Press ♦/♦ to highlight CLOCK SIT, then
press OK.
continu'd
Getting Staiteri | .i /
Setting the dock (continued)
Press ♦/♦to highhght AUTO, then press
OK.
4 Press ♦/♦ to highlight FULL AUTO, then
press OK.
Press ♦ / ♦ to highlight YLS, then press OK.
6
7
О Press MENU to exit the menu.
»1
To activate tl\e Auto Clock Set function, turn off the VCR.
The VCR automatically sets the clock by searching for a channel tliat
carries a time signal and sets your time zone and Daylight Saving
Time (if applicable).
If your clock is set to tl\e wrong time zone or Daylight .Saving Time,
you can adjust these settings without turning off the Auto Clock Set
feature (page 40).
Tip
• If you want to return to the previous menu, highlight RETURN and press OK.
Notes
• Ihe clock cannot be set automatically if you don't receive a channel tliat carries a
time signal in your area. If so, set the dock manually.
• If there are only a few channels in your area that cany time signals, setting the clock
automatically may take up to about 30 minutes. If noUting happens even after you
wait alx)ut 30 minutes, set the dock manually.
• If you use Hookup 1, make sure you leave the cable box on.