Sony SLV-789HF - Manual (Page 25)

t
Searching fora selected point on the tape (continued)
To cancel searching
Press t:- PLAY or ■ STOP.
To turn off the bar indication
Press DISPl^Y again.
Notes
• The figure on the bar indication represents tlie total time length of the inserted tape
as shown helow-
Thc total time length may not be displayed correctly for:
-tapes other than T-60, T-120, or T-160
- tapes recorded in more tlian one tape speed m<xlc.
Tape type
Total time length
T-60 or shorter
from T-80 to T-140
T-160 or longer
> If you move the poiixler (V) on the bar indication during search, the VCR searches
for the new reset point.
■ VYith the bar indication on, tiie ►>•0 IT/“^ and REW/^“ buttorcs on the
remote commander work only for moving the pointer (V), while the FI' and
REW buttons on the VCR are used for normal tape operation. Note, however, ii
you press these buttons on the VCR, searching is canceled.
Skip-searching
automatically
You can spot check a whole tape quickly.
Ai i/iter\'aJs, the VCR skip.s playback
while searching forward or backward.
Hold down ►► © FF (or © REW) for more
than two seconds during stop. "SKIP" indicator
appears on the TV screen.
The VCR searches forward (or backward) for
about two minutes on the counter, then fast-
forwards (or rewinds) for about ten minutes on
the counter. The VCR repeats this operation
until it stops at the end (or beginning) of the
tape.
search forward search forward
To cancel skip-search
Press O PLAY or ■ STOP.
Note
• The VCR automatically fast-forwards (or i vinds) any portion with no rcc'ording.
t
84 I /.dditional Operations Additional Operations
I
8b
Creating a
favorite channel
list with Station
ID
You can create your favorite channel list
of the TV channels with Station ID. You
cm slore up to 10 channels with Station
nb and select the channel from your
favorite channel list.
Before you starL..
• Set FAVORITF. CH to ON in the
ADVANCED OPTIONS menu
(page 101).
Creating your favorite channel list
■| . |; n TEK.
The FAVOKITH CH sert'en appears on the TV screen.
Press CH +/- to select the station ID you ^he selected stationJD
want to replace.
5 .ENTER o
Repeat steps 2 and 3 to set the station IDs a:; repi'in, d.
Press ENTER.
Press ♦■/■♦to select the station ID
you want to scd.