Step 1: select the dss receiver's rf security code, Set up remote, Rf security code – Sony SAT-A1 User Manual
Page 67: 70 chapter 6: using the installation menu
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the Security Code
The DSS receiver and remote control
are shipped with the RF security code
set to 000.
If the DSS receiver is accepting or receiving signals from another RF
remote control in your home (or from a neighbor's house), you can
eliminate this problem by changing the security codes for the DSS
receiver and remote control.
Note
y4s an alternative, you can eliminate this problem by disabling the RF
capability of the DSS receiver, if you have no need for RF transmission. See
"Selecting IR/RF Transmission" on page 69 for details.
There are two steps to changing the RF security code: Step 1 is
changing the DSS receiver's security code; step 2 is changing the DSS
remote control's security code. Both the receiver and the remote control
must use the same three-digit security code.
Step 1: Select the DSS Receiver's RF Security Code
1
Select SET UP REMOTE from the Installation Menu.
2
Select RF SECURITY CODE.
SET UP REMOTE
REMOTE SIGNAL
RF SECURITY CODE
RF ONLY
000
OK
CANCEL
IDENTIFY
HELP
3
Select a different security code and then select OK.
SET RF SECURITY CODE
CODE 000
CODE 001
CODE 002
CODE 003
CODE 004
CODE 005
CODE 006
CODE 007
CODE 008
CODE 009
yr
CODE 010
CODE Oil
CODE 012
CODE 013
CODE 014
CODE 015
CANCEL
HELP
4
Select OK from the Set Up Remote screen to save your changes and
return to the Installation Menu.
5
Go to "Step 2: Set the DSS Remote Control's RF Security Code" on
page 71 to continue.
70 Chapter 6: Using the Installation Menu